WeraDesk Web Interface Documentation - User's Guide

The Acquisition Mode field has the following options:
Continuous Acquisition	Start continuous acquisition cycles as defined in WeraDesk
Stop Continuous Acquisition	Stop continuous acquisition cycles; required before other modes are selected
Single Acquisition	Start one acquisition cycle immediately
Calibration	Start one calibration cycle immediately
Cont. Calibration	Start continuous calibration cycles as defined in WeraDesk
Stop Cont. Calibration	Stop continuous calibration cycles; required before other modes are selected
Internal Calibration	Start an internal calibration cycle
Full Calibration	Start a full calibration cycles - caution that takes ~ 5 houres
Interrupt Full Calibration	Interrupt/Stop full calibration cycles (if it takes too long)
FM raw Acquisition	Run WERA in chirp mode without internal range resolution
Cont. FM raw Acquisition	Start continuous FM raw acquisition cycles
Stop Cont. FM raw Acquisition	Stop continuous FM raw acquisition cycles; required before other modes are selected
Test Acquisition	Switch WERA to chirped mode without storing data; can immediately be stopped
Test Calibration	Switch WERA to non-chirped mode without storing data; can immediately be stopped
Test Internal Calibration	Switch WERA to internal calibration mode without storing data; can immediately be stopped
Test Stop	Stop one of the above Test Modes

Remarks

• Any continuous measurement mode must be stopped before another mode can be activated.
  Check the "Automatic Cycles" entry in the status page.
• Any TEST mode must be stopped before another mode can be activated.

BACK